Intec K20021 Bedienerhandbuch PDF herunterladen

Intec’s FORCE/2 Next Generation

Follow these steps to return tool to rentable condition:

Step

Action

Safety

First

Make sure you put on all appropriate safety equipment before you begin turning this tool.

For additional reference, refer to the Equipment Operation and Safety guide or Vendor

Instruction Manual.

Inspect hose for damage including cuts, kinks, and flat areas. Replace hose if current exhibits

these or other defects.

Inspect wired remote to ensure no cuts or frays in the wire. If damaged, repair prior to returning to

rentable condition.

Inspect Airlock Seals - Every 150 hours inspect airlock seals – This is a key aspect in assuring

your Intec machine is performing at maximum level. Inspect seals for wear, cuts, curling or brittle

texture. Also, if you notice material blowing back into the hopper, then you have a bad airlock seal.

The most accurate way to test the quality of the seals is to perform a psi test. If the readings are

level, then your seals are operational. If the reading is not level and “jumps” then you have a bad

seal.

Inspect switches for damage or loose connections. Correct if defects occur.

Inspect Power Cords – Inspect power cords after every use for cuts or tears. Repair or replace if

defects occur.

Gearbox - The oil in the gearbox of your FORCE/2 should be changed every year to ensure proper

lubrication of the gears and seals. Contact Intec for recommend oil in your operating temperature

range.

Blower – Keeping the blower as clean as possible will avoid system overheating. Upon return of

system, turn system on its side to inspect and clean blower by blowing with air.

Inspect blower brushes every three months or 100 hours of use. Replace brushes when they reach

1⁄4 inch or less in length. Change the brushes before the brush stunt touches the commutator.

When reassembling, the lead wires must be isolated from the motor frame and any rotating parts.

The tool is now ready to be returned to the shelf for rental.

Note:

Turning this tool and attaching a new service tag with your signature is extremely important. This

is your assurance that the tool is not defective and is in good working condition when the customer

rents it.

Labels

Ensure all required Safety and Rental labels are intact and appropriately affixed to the tool.

Inhaltsverzeichnis

Seite 1

Intec’s FORCE/2 Next Generation Follow these steps to return tool to rentable condition: Step Action Safety First Make sure you put on all appropriat

Weitere Dokumente für Nein Intec K20021

Um das Dokument anzuzeigen Intec K20021 Gebrauchs- und Pflegehandbuch

Intec K20021 Gebrauchs- und Pflegehandbuch (16 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Intec K20021 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Nein Intec K20021 herunter. Intec K20021 Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Nein Intec K20021

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Intec K20021